A Desirability Function for Evaluation of Corrosion Behavior for Nanocoated- Steel Using Electroless Technique

Authors

  • Muroog M. Shinyar University of Technology, Iraq
  • Abbas Kh. Hussein Nanotechnology and advanced materials research center
  • Laith K. Abbas Department of Materials Engineering

DOI:

https://doi.org/10.30684/etj.v39i6.2009

Abstract

The current work is conducting an experimental investigation into the effect of those technical parameters, called nanomaterial, bath temperature and plating time on the micro-hardness and corrosion rate of electroless plated low carbon steel undergoing electroless deposition operation. It was used to prepare (Ni-P/ Nano TiO2), (Ni-P/ Nano Al2O3) and (Ni -P/ Nano SiO2) alloys in this research. The Taguchi design is used to describe the variations located within the corrosion and mechanical properties. To achieve a comprehensive study, a Taguchi-based design was used to account for all applicable combinations of factors. Experimental models had been advanced that linking the response and method parameters to the results of those experiments. Validation of these models is done using analysis of variance (ANOVA). The desirability function is used to simultaneously optimize all the response. Finally, the optimum combination of method parameters resulting (bath temperature=90 oC, plating time =120 min.  and Nanomaterial=(Al2O3)), nanomaterial was observed to be the major process parameter on the responses of the electroless-plated low carbon steel with an impact ratio of (47%) based on the (ANOVA) results. 

Downloads

Download data is not yet available.

Metrics

Metrics Loading ...

Published

2021-06-25

How to Cite

Shinyar , M. M. ., Hussein, A. K. ., & Abbas, L. K. . (2021). A Desirability Function for Evaluation of Corrosion Behavior for Nanocoated- Steel Using Electroless Technique. Engineering and Technology Journal, 39(6), 946-955. https://doi.org/10.30684/etj.v39i6.2009